2X8GB DDR3 1866 KINGSTON HYPERX PREDATOR

KHX18C9T2K2/16X

16GB (8GB 1G x 64-Bit x 2 pcs.)
DDR3-1866 CL9 240-Pin DIMM Kit

DESCRIPTION

Kingston s KHX18C9T2K2/16X is a kit of two 1G x 64-bit (4GB)

DDR3-1866 CL9 SDRAM (Synchronous DRAM), 2Rx8 memory

modules, based on sixteen 512M x 8-bit FBGA components

per module. Each module kit supports Intel ® XMP (Extreme

Memory Profiles). Total kit capacity is 16GB. Each module kit
has been tested to run at DDR3-1866 at a low latency timing of

9-10-9 at 1.65V. The SPDs are programmed to JEDEC stan-
dard latency DDR3-1600 timing of 11-11-11 at 1.5V. Each 240-

pin DIMM uses gold contact fingers. The JEDEC standard
electrical and mechanical specifications are as follows:

XMP TIMING PARAMETERS

JEDEC: DDR3-1600 CL11-11-11 @1.5V
XMP Profile #1: D3-1866 CL9-10-9 @1.5V
XMP Profile #2: D3-1600 CL9-9-9 @1.5V

JEDEC standard 1.5V (1.425V ~ 1.575V) Power Supply

VDDQ = 1.5V (1.425V ~ 1.575V)

800MHz fCK for 1600Mb/sec/pin

8 independent internal bank

Programmable CAS Latency: 11, 10, 9, 8, 7, 6

Programmable Additive Latency: 0, CL - 2, or CL - 1 clock

8-bit pre-fetch

Burst Length: 8 (Interleave without any limit, sequential with
starting address “000” only), 4 with tCCD = 4 which does not
allow seamless read or write [either on the fly using A12 or
MRS]

Bi-directional Differential Data Strobe

Internal(self) calibration : Internal self calibration through ZQ
pin (RZQ : 240 ohm ± 1%)

On Die Termination using ODT pin

Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE < 95°C

Asynchronous Reset

PCB : Height 2.122” (53.90mm) w/ heatsink, double sided
component