GIGABYTE GA-Z77X-UP5 TH
• CPU
Support for Intel® Core™ i7 processors/Intel® Core™ i5 processors/ Intel® Core™ i3 processors/Intel® Pentium® processors/Intel® Celeron® processors in the LGA1155 package
• Chipset
Intel® Z77 Express Chipset
• Memory
4 x 1.5V DDR3 DIMM sockets supporting up to 32 GB of system memory
Dual channel memory architecture
Support for DDR3 2400+ (OC)/1600/1333/1066 MHz memory modules
Support for non-ECC memory modules
Support for XMP memory modules
• VGA
1 x D-Sub port
1 x DVI-D port, supporting a max. resolution of 1920x1200
* Simultaneous output for DVI-D and the MDP2 Thunderbolt port is not supported.
1 x HDMI port, supporting a max. resolution of 1920x1200
Intel DSL3510L chip:
2 Thunderbolt ports (MDP1/MDP2) support for Mini-DisplayPort and Thunderbolt monitor(s)
• Expansion Slots
1 x PCI Express x16 slot, running at x16 (PCIEX16)
1 x PCI Express x16 slot, running at x8 (PCIEX8)
1 x PCI Express x16 slot, running at x4 (PCIEX4)
* The PCIEX4 slot is available only when an Intel 22nm (Ivy Bridge) CPU is installed.
* Whether PCI Express 3.0 is supported depends on CPU and graphics card compatibility.
3 x PCI Express x1 slots
1 x PCI slot
Support for AMD CrossFireX™ / NVIDIA SLI
• Connectors
1 x 24-pin ATX main power connector
1 x 8-pin ATX 12V power connector
1 x PCIe power connector
3 x SATA 6Gb/s connectors
4 x SATA 3Gb/s connectors
1 x mSATA connector
1 x CPU fan header
4 x system fan headers
1 x front panel header
1 x front panel audio header
1 x S/PDIF Out header
1 x S/PDIF In header
3 x USB 3.0/2.0 headers
2 x USB 2.0/1.1 headers
1 x IEEE 1394a port
1 x Clear CMOS jumper
1 x Trusted Platform Module (TPM) header
1 x power button
1 x reset button
1 x Clear CMOS button
1 x BIOS switch button
Voltage Measurement Points
• Storage Interface
Chipset:
2 x SATA 6Gb/s connectors (SATA3 0/SATA3 1) supporting up to 2 SATA 6Gb/s devices
4 x SATA 3Gb/s connectors (SATA2 2~5) supporting up to 4 SATA 3Gb/s devices
1 x mSATA connector
Support for RAID 0, RAID 1, RAID 5, and RAID 10
* When a RAID set is built across the SATA 6Gb/s and SATA 3Gb/s channels, the system performance of the RAID set may vary depending on the devices being connected.
Marvell 88SE9172 chip:
1 x SATA 6Gb/s connector (GSATA3 8) supporting up to 1 SATA 6Gb/s device
1 x eSATA 6Gb/s connector on the back panel supporting up to 1 SATA 6Gb/s device
Support for RAID 0 and RAID 1
• Audio
Realtek ALC898 codec
Support for X-Fi Xtreme Fidelity® and EAX® Advanced HD™ 5.0 technologies
High Definition Audio
2/4/5.1/7.1-channel
Support for S/PDIF In/Out
• LAN
1 x Intel GbE LAN chip (10/100/1000 Mbit)
• Rear Panel I/O Ports
1 x D-Sub port
1 x DVI-D port
1 x optical S/PDIF Out connector
1 x HDMI port
2 x Thunderbolt ports
1 x eSATA 6Gb/s connector
4 x USB 3.0/2.0 ports
2 x USB 2.0/1.0 ports
1 x RJ-45 port
5 x audio jacks (Center/Subwoofer Speaker Out, Rear Speaker Out, Line In, Line Out, Mic In)
• BIOS
2 x 64 Mbit flash
Use of licensed AMI EFI BIOS
Support for DualBIOS™
PnP 1.0a, DMI 2.0, SM BIOS 2.6, ACPI 2.0a
• Form Factor
ATX
• Dimensions
30.5cm x 24.4cm
• Package
Box