KINGSTON ValueRAM DDR3 SDRAM ECC KVR16R11D4/16

DESCRIPTION

 

This document describes ValueRAM s 2G x 72-bit (16GB)

 

DDR3-1600 CL11 SDRAM (Synchronous DRAM), registered w/

 

parity, 2Rx4 ECC memory module, based on thirty-six

 

1G x 4-bit FBGA components. The SPD is programmed to

 

JEDEC standard latency DDR3-1600 timing of 11-11-11 at

 

1.5V. This 240-pin DIMM uses gold contact fingers. The

 

electrical and mechanical specifications are as follows:

 

FEATURES

 

JEDEC standard 1.5V (1.425V ~1.575V) Power Supply

 

VDDQ = 1.5V (1.425V ~ 1.575V)

 

800MHz fCK for 1600Mb/sec/pin

 

8 independent internal bank

 

Programmable CAS Latency

11, 10, 9, 8, 7, 6

Programmable Additive Latency

0, CL - 2, or CL - 1 clock

8-bit pre-fetch

 

Burst Length

8 (Interleave without any limit, sequential with

starting address “000” only), 4 with tCCD = 4 which does not

 

allow seamless read or write [either on the fly using A12 or

 

MRS]

 

Bi-directional Differential Data Strobe

 

Internal(self) calibration

Internal self calibration through ZQ

pin (RZQ

240 ohm ± 1%)

On Die Termination using ODT pin

 

On-DIMM thermal sensor (Grade B)

 

Average Refresh Period 7.8us at lower than TCASE 85°C,

 

3.9us at 85°C < TCASE < 95°C

 

Asynchronous Reset

 

PCB

Height 1.180” (30.00mm), double sided component

Последно добавени продукти в категорията: